
Irrigation · Columbus
Sprinkler Winterization & Blowouts in Columbus, Ohio
Sprinkler winterization protects your irrigation lines, valves, and backflow from freeze damage. It’s right for any Columbus homeowner with a lawn sprinkler or drip zone. First, we shut off your irrigation water, isolate and drain the backflow, then use regulated compressed air to blow out each zone. You get notes for spring and a system ready for cold.
What is included with sprinkler winterization?
We prepare your irrigation system for freezing weather and leave it safe until spring. You get careful shut-down, a complete blowout, and clear notes on any repairs to plan for later. We’re a family-run team based in Columbus.
Here is what a standard winterization visit includes:
Shut off irrigation water at the main or stop-and-waste valve
Isolate and drain the backflow preventer (RPZ or PVB) and open test cocks
Zone-by-zone compressed air blowout with regulated pressure appropriate to your system (ask your installer)
Drip lines and manifolds purged and left open as needed
Visual check of heads and valves; we flag broken or low heads
Controller set to “off” or winter mode; schedules saved if available
How the work goes, step by step
- 1
Arrival and locate shutoffs. We confirm the irrigation shutoff location (often in the basement or a crawl space) and the outdoor backflow. We review zone count and any trouble spots you noticed over summer.
- 2
Shut down and drain. We close the irrigation shutoff, relieve pressure, and open the backflow test cocks to drain. Then we connect a compressor to the system blowout port. We never use unregulated shop air directly into the system.
- 3
Blow out every zone. We run one zone at a time, starting with zones furthest from the water source. We keep air pressure in the safe range for residential systems and cycle until only a light mist appears. Drip zones are cleared at low pressure to protect emitters.
- 4
Finish and set for winter. We open any low-point drains, leave backflow test cocks open at 45°, and place isolation ball valves in a position that won’t trap water. The controller is set to off. You receive notes and, if you like, a reminder for spring start-up. Learn more about our full irrigation services and our work on irrigation in Columbus.
What about Columbus and central Ohio makes this important?
Freeze–thaw cycles hit hard here. Our frost depth reaches well below typical sprinkler laterals. Many lawn lines sit 6–12 inches deep, so water left inside will expand and crack fittings when temperatures drop into the 20s.
Clay soil is common across Franklin and surrounding counties. Clay holds water and creates low spots in trenches. Those pockets freeze first. A proper blowout clears these low spots better than relying on drain valves alone.
Backflow devices are usually above grade near the foundation. They are exposed to wind and sudden cold snaps. Winterization drains the device; an insulated cover adds extra protection. Winterization itself doesn’t require a permit. Many water providers in central Ohio, including Columbus, require annual backflow testing—check with your water provider or ask your installer. For repairs or replacements of backflow assemblies, a plumbing permit may be needed.
How to decide between winterization options
Blowout vs. drains only. Some systems have automatic or manual drains. In Ohio, a full air blowout is still recommended. Drains can clog with debris or stick closed, and clay soils leave water in low points. A blowout removes what drains miss.
Air pressure and equipment. Small “pancake” compressors rarely move enough air to clear a system. Most residential systems need good airflow (CFM) at modest pressure. Pros use high-CFM compressors and regulate pressure—typically around 40–60 PSI for many residential PVC systems and lower for drip. If you are unsure what’s safe for your system, ask your installer.
Backflow care and add-ons. Both PVB and RPZ devices must be isolated and drained. An insulated cover helps with wind chill. If your shutoff is hard to reach, consider adding an accessible valve or drain point during spring service. If your system needs upgrades, see our irrigation installation page for options to modernize controls and valves. For homeowner pointers, these winterization tips also apply in Columbus.
How to prepare for your appointment
Make sure we can reach the indoor irrigation shutoff and the outdoor backflow. Clear a path to the mechanical room, unlock gates, and trim back any shrubs blocking the backflow. Note any zones that didn’t perform well this season.
Pets should be secured, and vehicles moved if they block access to the driveway or valve boxes. If your controller is app-based, have your login handy in case we need to save schedules. If you have a rain barrel tie-in or filter on drip lines, let us know.
Know where your irrigation shutoff is (basement or crawl space)
Unlock gates and garage if access is needed
Remove decorative backflow covers before we arrive
Mark soft spots or known leaks for us to check
Controller left plugged in; we’ll place it in winter mode
Get your free quote
Tell us a little about your project and we will get back to you, or call 614-596-8141.
Frequently asked questions
When should I winterize sprinklers in Columbus?
Plan between late October and mid-November, before we get several nights in the low 20s. A light early frost is a warning sign. If a hard freeze is forecast and your system is still on, shut the irrigation water off immediately and schedule a blowout as soon as possible.
Do I need a blowout if my system has auto-drain heads or I only run drip?
Yes. Auto-drains and drip emitters can leave water in low spots and fittings, especially in clay soils. A controlled air blowout removes what gravity can’t. For drip, we use lower pressure and may open the ends to clear lines without damaging emitters or filters.
What air pressure is safe for winterization?
Residential systems are cleared with modest pressure and good airflow. Many PVC systems are blown out around 40–60 PSI; polyethylene laterals and drip need less. The key is high CFM with regulated pressure, and cycling zones until only a light mist remains. If unsure, ask your installer.
What should be done with the backflow preventer?
We isolate it, drain it, and open the test cocks so no water is trapped. An insulated cover helps in windy spots. Winterization is separate from annual testing. Columbus-area providers typically require yearly backflow testing—schedule that with a certified tester and keep the report on file.
How long does sprinkler winterization take and do I need to be home?
Most homes take under an hour once we’re set up, depending on zone count and drip. We need indoor shutoff access, so someone should be home or provide entry. After the blowout, we set the controller to off and leave notes for any spring repairs.
Ready to protect your system before it freezes? Call Brothers Irrigation & Lighting at 614-596-8141 or request a free quote and we’ll get your Columbus sprinkler winterized on time.
